“Pimp
Daddy” Rolling Chassis Kit
“Pimp Daddy” is the ultimate in Retro-Cool! Reminiscent of a stripped
down ‘48 Pan, we’ve assembled all the hard to find parts to build
the “Bobber” of your dreams! From the old-style floorboards to
the classic springer front end, this Rolling Chassis kit’s got cool
written all over it! • Straight leg style rigid frame with tank mounts
for pre 1984 Fat Bob tanks (for use with chain rear drive and 4-speed tranny)
with 2” stretch in down-tubes and 33 degree rake. (includes frame cups
and heavy-duty bearings). Accepts any Big Twin engine, including Strokers,
and Evo's (except Twin-Cam 88). Uses any stock type hydraulic drum or disc
brake set-up from 1958 -1983. • Old style oval floorboards with weld-on
tabs and brackets. • Heavy-duty kickstand and bracket. • FXST
style shifter/brake kits with chrome rear master cylinder. • 12V Bottom
mount 6-1/2 inch headlight assembly with lowering block. • Stock length
Springer with axle kit and fender. • GMA billet dual-action front brake
caliper, stabilizing link and mounting hardware. • White Bros. 36"
wide 1” Bikini Beach Bars • 21" chromed 40 spoke front wheel
(single flange) with a 3.00 X 21" Speedmaster blackwall tire, rim strip
and tube. • 16" chromed 40 spoke rear wheel (dual flange) with
a 5.10 X 16" Classic wide whitewall tire, rim strip, tube and rear axle
kit. • Chromed 3-1/2 quart side-fill hex wrap-around oil tank. •
3.5 gallon Fat Bob style gas tanks for screw-in type gas caps • Chrome
cateye dash kit complete with 1:1 ratio speedo, mounting kit and electronic
ignition switch. • 6" flat rear fender with chromed
fender brace and chromed Sparto style taillight. • Assorted hardware.
171030 “Pimp Daddy” Rolling Chassis Kit $4,858.00
Copyright 2005. Global Motorsport Group, Inc. All Rights Reserved